Black Box Advanced Console Server Manuale Utente Scaricare il pdf (Pagina 63)

_____________________________________________________________________

724-746-5500 | blackbox.com Page 63

 When configuring the principal network connection, specify Network 2 (eth1) as the Failover

Interface to use when a fault is detected with Network 1 (eth0).

 Specify the Probe Addresses of two sites (the Primary and Secondary) that the Advanced Console

Server is to ping to determine if Network 1 (eth0) is still operating.

 On the Management LAN Interface - Network 2, configure the IP Address/Subnet Mask/Gateway

the same as Network Interface - Network 1.

In this mode, Network 2 (eth1) is available as the transparent back-up port to Network 1 (eth0) for

accessing the management network. Network 2 will automatically and transparently take over the work

of Network 1, if Network 1 becomes unavailable for any reason. When Network 1 becomes available

again, it takes over the work again.

5.4 Dial-Out Failover

The console servers can be configured so a dial-out PPP connection is automatically set up in case the

principal management network is disrupted:

 When configuring the principal network connection in System: IP, specify Internal Modem (or the

Dial Serial DB9 if you are using an external modem on the Console port) as the Failover Interface to

use when a fault is detected with Network1 (eth0).

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 236 237

Nessun commento

Black Box Advanced Console Server Manuale Utente Pagina 63