Black-box LR1530A-EU-R3 Manuale Utente Scaricare il pdf (Pagina 82)

Servicing Information

Sanity Timer

Do not remove this strap – pins 1-2.

Force ZMODEM Software Load

On the rare occasion that during the programming of the FLASH

something happens to the bridge/router (power hit or hardware reset),

causing the FLASH to become corrupted, the bridge/router will restart

in ZMODEM receive mode only. If the bridge/router does not start in

ZMODEM receive mode, perform the following steps:

1) power down the bridge/router,

2) open the case,

3) remove the strap from the center set of pins: 3-4,

4) power up the bridge/router. The bridge/router should now restart

and be in ZMODEM receive mode.

5) Re-install the strap and replace the cover.

Please refer to Appendix E or the Menus Reference Manual for

information on how to do software upgrades.

To Clear a “Lost” Password

1) Remove power from the bridge/router.

2) Remove the case cover.

3) Remove the jumper strap on pins 5-6.

4) Re-attach the power to the bridge/router and wait for Power LED

to go green.

5) Remove power from the bridge/router.

6) Re-install the jumper strap on pins 5-6.

7) Install the case cover

8) Power up the bridge/router.

9) Log into the bridge/router using the default password “BRIDGE”

and change the password as desired.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 101 102

Nessun commento

Black-box LR1530A-EU-R3 Manuale Utente Pagina 82